Acclimatization - HP 3PAR StoreServ 7450c Planning Manual

Hide thumbs Also See for 3PAR StoreServ 7450c:
Table of Contents

Advertisement

Disk drive magazine container: Height 38 inch (96.5 cm) x Width 29 inch (73.6 cm) x Depth
34 inch (86.4 cm)
Approximate shipping weight: 392 lb (177.8 kg)
Node enclosure container: Height 30 inch (76.2 cm) x Width 35 inch (88.9 cm) x Depth 45
inch (1 14.3 cm)
Approximate shipping weight: 618 lb (280.3 kg)
When the equipment arrives, you must make sure that there is enough room to unload and unpack
the storage system.
The specific amount of space you will need to unpack the storage system is based on the dimensions
of the container, the ramp, and the room required to access the storage system so that it can be
moved to its placement destination.
NOTE:
See
the storage systems and reserving room for service access.

Acclimatization

Storage systems are shipped or stored at extreme temperatures and may require time to adjust to
operating temperatures before startup. The maximum acceptable rate of temperature change for
a non-operating system is 36° F/hour (20° C/hour). The storage system requires time to acclimatize
to new environmental conditions before being powered on. During that time, it is possible to
proceed with the physical installation of the storage system. However, the storage system may
need at least 24 hours to acclimatize to a new environment prior to completing the full system
installation. If condensation is present even after the 24-hour acclimatization period, it is necessary
to wait until all condensation has evaporated before completing the power-on sequence.
"Structural/Environmental Considerations" (page 18)
for more information on placing
Acclimatization
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

3par storeserv 7450

Table of Contents