Installation; High Altitude Mode; Emulate; Function Button - Panasonic PT-F300E Operating Instructions Manual

PROJECTOR SETUP menu

INSTALLATION

When installing the projector, select the projection
method according to the projector position. Press I H
to cycle through the options. See "Projection method" on
page 18.
FRONT/DESK
FRONT/CEILING
REAR/DESK
REAR/CEILING

HIGH ALTITUDE MODE

If you use the projector at high elevation, the HIGH
ALTITUDE MODE setting needs to be ON to set the fan
speed high. Press I H to select the required option.
OFF
ON
NOTE:
• At 1 400 m (4 593 ft) above sea level, the setting must
be ON.
• The loudness of fan noise depends on the HIGH
ALTITUDE MODE setting.

EMULATE

You can switch to the Panasonic past model's control
commands for COMPUTER connection.
DEFAULT
D3500
D4000
D/W5K series
L730
L780
L735
L785
LB/W80
E
NGLISH - 44
Setting on a desk/floor and
projecting from front
Mounting on the ceiling and
projecting from front
Setting on a desk/floor and
projecting from rear
Mounting on the ceiling and
projecting from rear
The fan speed is low.
The fan speed is high.
F100, FW100, F200, F300,
FW300 models
D3500 models
D4000 models
D5500, DW5000, D5600,
DW5100, D5700 models
L520, L720 models
L750, L780 models
L735 models
L785 models
LB75, LB80, LW80 models

FUNCTION BUTTON

You can assign a certain menu function to the
FUNCTION button as shortcut. Press I H to select the
required menu option, and the ENTER button.
Options
Deactivate the FUNCTION
DISABLE
button.
ASPECT Display the ASPECT menu.
Display the PICTURE MODE
PICTURE MODE
menu.
Display the DAYLIGHT VIEW
DAYLIGHT VIEW
menu.
NOTE:
• Without any operation for 5 seconds, the displayed
menu will be disappeared.

AUDIO SETTING

VOLUME
You can adjust the volume of the built-in monaural
speaker and VARIABLE AUDIO OUT terminal.
Decrease
I
Increase
H
BALANCE
You can adjust to hear the sound played equally
through both right and left from VARIABLE AUDIO
OUT, or shift the balance so more sound plays
through the left or right side.
More sound plays through the left
I
side
More sound plays through the right
H
side
IN STANDBY MODE
You can switch on/off the sound output in standby mode.
OFF No sound in standby mode.
ON Output audio in standby mode.
AUDIO IN SELECT
You can switch the audio output method for
COMPUTER1 IN, COMPUTER2 IN and DVI-D IN
terminals.
DVI
COM.AUDIO IN 2
Output audio that is input to the
COMPUTER AUDIO 2.
AUDIO IN Output audio that is input to the
AUDIO IN.
COMPUTER1
COM.AUDIO IN 1
Output audio that is input to the
COMPUTER AUDIO 1.
AUDIO IN Output audio that is input to the
AUDIO IN.
Functions Refer
-
38
35
36