Table of Contents
Advertisement
Other operations for connection
Searching by projector's ID
Even if there are two or more projectors with the same name, an ID ([Proj] + 4-digit number) is assigned to each projector to
enable the projectors to be identified.
When you click [ID Search], a search for the projector of the specified ID is carried out from among the projectors that are
presently switched on, from all network numbers other than [U].
It is necessary to know ID in advance. When input selection is switched to [NETWORK] on a projector, the ID appears on the
upper right of the projection screen for approximately 5 seconds. If you write down the ID displayed in the [ID] column of the
[Details] screen on the <Select Access Port> window in advance, you can search a projector by the ID from next time.
Click [Select Access Port] in the menu.
1
The <Select Access Port> window appears.
For procedures for displaying menus, see page 21.
Click [ID Search].
2
<Projector ID Search> window appears.
Enter four figures of desired projector's ID, and click [Search].
3
Start Searching.
When the projector of the applicable ID is found, the computer will be connected to
4
that projector, and the status display of the menu bar will turn green.
If appropriate ID is not found, an error message appears.
(cont.)
19
Advertisement
Table of Contents
