Table of Contents
Advertisement
Connecting with wireless LAN
In [Network], select the same network number as is displayed in the [WIRELESS
2
LAN] menu of the projector to connect.
Projectors powered on in the chosen network group are listed.
Select the desired projectors, and click [OK].
3
[
] appears in the menu bar and a connection is established with the projector.
("Menu description"
• Easy Wireless Set Up cannot be made between the projector and the computer. (See page 46)
• Automatic connection setting (See page 26)
※1
• In the following situation, connections other than [U] are not possible.
- When not installed in the [Applications] folder
• Depending on the computer and wireless LAN card used, Easy Wireless Set Up may not be possible. If this is the case,
the [Network] setting of <Select Access Port> window will be switched to [U] automatically. For details of the connection
procedure, first close Wireless Manager ME 4.5, and then refer to page 15.
※2
• The initial network number for both the projector and Wireless Manager ME 4.5 is [1]. These numbers must match for the
connection. To check the network number, refer to the network menu of the projector.
• Although WEP (Wired Equivalent Privacy)
network numbers [2] through [4], so set [2] through [4] if security is to be emphasized.
• Important image data is protected because AES
even if [ENCRYPTION] is set to [NONE].
• Other network adapters may not be usable under Easy Wireless Set Up connections.
• Connections to other networks connected through the wireless LAN card are broken under Easy Wireless Set Up
connections.
※ "Glossary" (See page 45)
See page 21)
※
is not set for network number [1], WEP (Wired Equivalent Privacy)
※
encryption processing takes place in advance for all network numbers,
(cont.)
13
※
is set for
Advertisement
Table of Contents
