Video - Panasonic AJ-HPM100P Operating Instructions Manual

Item
FR SUPER
No. DISP.
0000
515 HD EMBD LTC 0001
0000
0001
518 VITC GEN
0000
0001
519 UB OUT SEL
Definition of terms:
SBC (Sub Code Data) area:
VAUX (Video Auxiliary Data) area:

VIDEO

This menu is used for video settings.
Item
FR SUPER
No. DISP.
0000
0001
0002
601 VIDEO INT SG
0003
0004
0000
0001
602 SDI IN MODE
0000
DOWNCON
0001
620
MODE
0002
0000
0001
621 UPCONV MODE
0002
Setting
FR SUPER
No. DISP.
OFF Specifies whether or not LTC data will be superimposed on HD SDI output.
ON 0: Not superimposed
1: Superimposed
OFF Specifies whether or not the internal time code generator value should be recorded in the
VAUX area.
ON
0: The internal time code generator value is not recorded.
Record the time code value when it is superimposed on input video signals.
1: The internal time code generator value is recorded.
NOTE:
When 1394 is selected as the input signal, the time code signal superimposed on the
compressed input signal is recorded regardless of settings in this menu.
SBC Selects user bits in the LTC data output by the TIME CODE OUT and HD SDI connectors
F_RATE or user bits in the SBC area (DVCPRO HD only) output via the IEEE 1394 terminal during
playback of clips in 720/24PN, 720/30PN and 720/25PN formats as well as optional AVC-
Intra 1080/24PN, 30PN and 25PN clip formats.
0: Outputs the user bits recorded in the SBC area.
1: Outputs the frame rate information recorded in the VAVX area.
This area, which is separate from video and audio data area on a P2 card, stores SMPTE/
EBU compliant time code, recording dates and other information.
An area in the video data area on a P2 card that stores additional information on video
data.
Setting
FR SUPER
No. DISP.
100%CB
Sets the internal signal type. SMPTE and ARIB signals are available in HD mode only (black
in SD mode).
75%CB
0: 100% color bar
SMPTE
1: 75% color bar
ARIB
2: SMPTE color bar
BLACK
3: ARIB color bar
4: Black
DR OFF Specifies the method for processing HD SDI input. (Available only for DVCPRO HD)
0: Records the 8 higher bits after rounding up the two lowest bits.
DR ON
1: Records the signal with 8 higher bits, obtained by dynamic rounding.
NOTE:
Records 8 high-order bit signals after rounding off the 2 low-order bits during SD SDI
input.
CROP Specifies the picture angle during down-conversion.
0: Side cut mode
LT-BOX
1: Letter box mode
SQUEEZ
2: Squeeze mode
S-PANL Specifies the picture angle during up-conversion.
0: Side panel mode
CROP
1: Top and bottom cut in vertical direction
STRECH
2: Stretch mode
Settings and brief function description
* An underlined setting indicates an initial value.
Settings and brief function description
119
Setup: Item Settings