Picture Menu Operation; Menu; Contrast, Brightness, Colour, Sharpness, Ntsc-Tint; Colour Temperature - Panasonic QUINTRIX TX-86PW300A Operating Instructions Manual

Push the PICTURE button.
Select the option.
Adjust the chosen option.
Push the TV/AV at any time to return
to watching TV.

MENU

Contrast
Brightness
Colour
Sharpness
Tint (AV only)

Colour temperature

P-NR

Scan mode

Notes:
1. You can change the level for each function (Contrast, Brightness, Colour, Sharpness and NTSC-Tint) for
each picture menu option.
2. Picture menu levels can be set for TV, AV1, AV2, AV3, AV4 and AV5 modes.
3. NTSC-TINT only appears when the TV is receiving NTSC signals and the television is in the AV mode.
4. Only CONTRAST will be displayed in TELETEXT mode.
5. We recommend that you set the Scan mode to Progressive when viewing a PAL 60 or NTSC
transmission. When viewing a PAL transmission (other than PAL 60) with the Scan mode set to
Progressive, the screen will flicker. This is not a fault.
6. The Multipip function will not operate when a Progressive signal is used.
Normalisation
Pressing the Normal (
levels. This is called "Normalisation".
Normalisation will only occur if the Picture Menu is not displayed when the Normal (
The Viewing mode control allows you to change the Picture setting between Dy-
namic, Normal and Cinema.
Dynamic For viewing in brightly lit rooms. This menu selects higher than normal
levels of Brightness and Contrast.
Normal For viewing in normal (evening lighting) environments. This menu
selects the normal levels of Brightness and Contrast.
Cinema For viewing in a dark room. This menu selects reduced levels of
Brightness and Contrast.
Contrast
Increase or decrease the level of these options to suit your personal preference.
The Colour temperature control allows you to change the White balance setting
between Standard, Warm and Cool. .
The P-NR (Picture Noise Reduction) system is designed to reduce picture noise
during poor quality reception conditions. Pushing the left or right buttons will change
the setting between Off, Strong, Weak and Auto.
The Scan mode control allows you to change the Picture refresh setting between
75/883i, 100Hz and Progressive.
The 75/883i mode gives a faster refresh rate and more lines than a standard
television. 100Hz will give a steady picture for most signals. Progressive is
recommended when receiving NTSC signals.
NOTE: The scan mode function is not available when Picture in Picture is being
used.
N
) Button on the remote control, will return all picture settings to the factory preset
Picture Menu
RF Mode
Pictu re menu
Menu
Contrast
Brightne ss
AV Mode
Co lo ur
Sharpness
NTSC-Tint
Colou r Temp erat ure Stand ard
P-NR Au to
Scan mode 7 5 / 83 3i
) Button is pressed.
Picture menu
Menu
Contrast
Bright ness
Colour
S harpness
Colour Temperature Standard
P-NR Auto
Scan mode 75 / 833i
15