Table of Contents
Advertisement
AUDIO input and output connectors (stereo mini
jack)
IN connector
Connect to the audio outputs of external equipment
such as a VCR.
OUT connector
Outputs the audio signal which is selected by the input
select button on the front panel.
The outputting audio can be changed in [Audio
Setting] (page 30) of the [User Configuration] menu.
Note
Output is only activated when the power is on.
HDMI cable holder
Secures the HDMI cable (Ø7 mm or less).
Rotate to unlock the HDMI cable holder first, then
remove it.
HDMI IN connector
Input connector for HDMI
HDMI (High-Definition Multimedia Interface) is an
interface that supports both video and audio on a single
digital connection, allowing you to enjoy high quality
digital picture and sound. The HDMI specification
supports HDCP (High-bandwidth Digital Content
Protection), a copy protection technology that
incorporates coding technology for digital video signals.
1) The terms HDMI and HDMI High-Definition Multimedia
Interface, and the HDMI Logo are trademarks or
registered trademarks of HDMI Licensing LLC in the
United States and other countries.
Note
Use an HDMI cable bearing the High-Speed logo (Sony
product recommended).
PARALLEL REMOTE connector (RJ-45, 8-pin)
Forms a parallel switch and controls the monitor
externally.
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
12
Location and Function of Parts and Controls
Close
Cable
1)
signals.
Pin assignment
Pin number
Functions
1
Designating [SDI1] input signal
2
Designating [SDI2] input signal
3
Designating [HDMI] input signal
4
Designating [Composite] input signal
5
GND
6
[WFM/ALM/Vector]
7
[Tally Green]
8
[Tally Red]
You can assign functions using the [Remote] menu (see
page 31).
Wiring required to use the Remote Control
Connect the function you want to use with a Remote
Control to the Ground (Pin 5).
SERIAL REMOTE connector (RJ-45)
Connect to the Sony BKM-15R/16R Monitor Control
Unit by using a 10BASE-T/100BASE-TX LAN cable
(shielded type, optional).
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
When you connect the SERIAL REMOTE cable of the
unit to peripheral device, use a shielded-type cable to
prevent malfunction due to radiation noise.
The connection speed may be affected by the network
system. This unit does not guarantee the
communication speed or quality of 10BASE-T/
100BASE-TX.
(DC) input connector (PVM-A170 only)
Plug the DC power supply to this connector to provide
power to the monitor.
It runs on DC 12 V to 16 V.
CAUTION
Be sure to connect to a power supply of the specified
voltage.
Pin assignment
Hide quick links:
Advertisement
Table of Contents
