Setting Remote Control Codes; Resetting All Remote Control Codes - Yamaha RX-V363 Owner's Manual

Remote control features

Setting remote control codes

You can control other components by setting the
appropriate remote control codes. For a complete list of
available remote control codes, refer to "List of remote
control codes" at the end of this manual.
Remote control code default settings
Input Component
source category
CD CD
MD/CD-R CD-R
TUNER TUNER
DVD DVD
DTV/CBL —
V-AUX TUNER
DVR DVR
A TUNER
B TUNER
C TUNER
D —
E —
Note
You may not be able to operate your Yamaha component even if a
Yamaha remote control code is preset as listed above. In this case,
try setting another Yamaha remote control code.
52
En
Default
Manufacturer
code
Yamaha 5013
Yamaha 5001
Yamaha 5007
Yamaha 2000
— —
Yamaha 5011
Yamaha 2011
Yamaha 5012
Yamaha 5009
Yamaha 5017
— —
— —
1
While pressing and holding one of the input
selector buttons ( 3 ) on the remote control to
select the input area you want to set up,
press 2 AV POWER for more than 3
seconds.
A B C
CD MD/CD-R TUNER
DVD DTV/CBL DVR
V-AUX D E
While holding down
2
Press the numeric buttons (0 to 9) ( N ) to
enter the four-digit remote control code for
the component to be used.
When the setting succeeds, "RemoteSetup OK"
appears; however, when it dues not, "RemoteSetup
NG" appears in the front panel display.
Notes
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• If you do not press any buttons within 30 seconds in step 2, the
setup process is canceled. If this happens, repeat the setup
procedure.

■ Resetting all remote control codes

Use this feature to clear all the remote control codes
previously set and reset all of them to the initial factory
settings.
While pressing and holding 4 AMP, press
1
2 AV POWER for more than 3 seconds.
AMP
While holding
down
2
Press the numeric buttons ( N ) to enter the
code number "9981".
"RemoteSetup OK" appears in the front panel
display, and the remote control codes previously set
are cleared and reset to the initial factory settings.
y
If you do not press any buttons within 30 seconds after
step 1, the clearing process is canceled. In this case, repeat
the clearing procedure.
POWER
AV
Press for 3
seconds
POWER
AV
Press for 3
seconds