Konica Minolta bizhub Pro C6500 User Manual page 40

Introduction/ Safety Information
Output for Machine with Finisher FS-503 Installed:
Non-Sort, Collate, Uncollate, and Staple modes using the primary (main) tray
Collated and Uncollate modes using the secondary (sub) tray
Selects an output tray and output mode on the Output Application Screen.
Output for Machine with Finisher FS-607 Installed:
Non-Sort, Collate, Uncollate, and Staple modes using the primary (main) tray
Collated and Uncollate modes using the secondary (sub) tray
Selects an output tray and output mode on the Output Application Screen.
Output for Machine with Large Capacity Stacker LS-501 Installed:
Non-Sort, Collate, and Uncollate modes using the stacker
Collated and Uncollate modes using the stacker secondary (sub) tray
Selects an output tray and output mode on the Output Application Screen.
Output for FS-503 Finisher with Folding Unit FD-501 Installed:
Punch
Folding (Z-fold, Tri Fold-in, Tri Fold-out, Double Parallel, Gate, Folding)
Cover sheet feeding
Output for Machine with SD-501 Saddle Stitcher Installed:
Fold & Staple, Trimming
Folding (Multi Half Fold, Multi Tri-Fold)
Page Margin
Creates or removes a binding margin at the top, bottom, right and left edges
(shift amount from 0 ~ 250mm, in 1mm increments); reduces image to pre-
vent image loss (reduce & shift amount from 0 ~ 250mm, in 1mm incre-
ments).
Program Overlay
Same as for Image Overlay except the overlay image is stored in memory.
Power Save
Automatically turns off all but nominal power supply after a specified period
of copier inactivity, for optimal efficiency. Power is returned after a brief
warm up period by pressing [Power Save] on the control panel.
bizhub PRO C6500
1
1-31