Specifications - Makita BHR162 Instruction Manual

ENGLISH (Original instructions)
1-1. Red indicator
1-2. Button
1-3. Battery cartridge
2-1. Star marking
3-1. Switch trigger
3-2. Lamp
4-1. Switch trigger
4-2. Lamp
5-1. Reversing switch lever
6-1. Lock button
6-2. Rotation with hammering
6-3. Action mode changing knob
7-1. Rotation only

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : hammer drilling into concrete
Vibration emission (a
Uncertainty (K) : 2.0 m/s
Explanation of general view
8-1. Grip base
8-2. Side grip
8-3. Loosen
8-4. Tighten
8-5. Teeth
8-6. Protrusion
9-1. Bit shank
9-2. Bit grease
10-1. Bit
10-2. Chuck cover
11-1. Bit
11-2. Chuck cover
12-1. Depth gauge
Model
Concrete
Steel
Wood
-1
)
Overall length
Net weight
Rated voltage
) : 85 dB(A)
pA
) : 96 dB(A)
WA
2
) : 12.5 m/s
h,HD
2
ENE042-1
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
ENG905-1
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENG900-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
13-1. Dust cup
15-1. Blow-out bulb
16-1. Chuck adapter
16-2. Keyless drill chuck
17-1. Sleeve
17-2. Ring
18-1. Limit mark
19-1. Holder cap cover
19-2. Recessed part
20-1. Brush holder cap
20-2. Screwdriver
BHR162
16 mm
13 mm
24 mm
0 - 1,500
0 - 5,000
296 mm
2.4 kg
D.C. 14.4 V
2
) : 3.5 m/s
h,D
2
ENG901-1