Sharp AE-Z40KR Service Manual page 14

AYZP40KR
1.18. Airflow control
1)Press the SWING button( 1)Pr 1)Pr
The vertical adjustment louvre will swing continuously. The vertical adjustment louvre will swing continuously. T uvre will swing continuously.
2)Press the SWING butto n 2)Press the SWING butto n( NG butto
vre is at the desir ed position. vre is at the desir ed position. the desir ed position.
The louvre will stop moving within the range shown in the diagram. The louvre will stop moving within the range shown in the diagram. The louvre will stop moving within the range shown in the diagram.
The adjusted position will be memoried and will be automatically set The adjusted position will be memoried and will be automatically set The adjusted position will be memoried and will be automatically set
to the same position when operated the next time. to the same position when operated the next time. to the same position when operated the next time.
1) Press the SWING button
(
The horizontal adjustment louvres will swing continuously.
2) Press the SWING button(
louvres are at the desired position.
The adjusted position will be memorized and will be automatically set
to the same position when operated the next time.
1.20. Difference of operation in Auto and Manual modes
In the Auto mode, the temperature setting is automatically determined based on the outside air temperature. In addition, the air conditioner operation
differs from the operation in the Manual mode as explained below.
1.21. Difference relating to set temperature
Cooling
Temperature Automatic temperature setting based on outside air tem-
perature. Can be changed within 2C using remote con-
setting
method trol.
1.22. Dehumidifying operation control
If the room temperature is 26C or higher when dehumidifying opera-
tion starts, the dehumidifying operation provides a low cooling effect in
accordance with the room temperature setting automatically deter-
mined based on the outside air operation. (The setting value is the
same as the set temperature for cooling operation in the auto mode.)
If the room temperature is lower than 26C when dehumidifying opera-
tion starts, the dehumidifying operation minimizes the lowering of the
room temperature.
1.23. FULL POWER Operation
In this operation, the air conditioner works at the maximum power and
optimum louvre direction to make the room cool or warm rapidly.
During operation, press the FULL POWER button.
on the remote control once. on the remote control once.
again when the vertical adjustment lou- again when the vertical adjustment lou- again when the vertical adjustment lou-
) on the remote control once.
again when the horizontal adjustment
)
Auto mode
Heating Dehumidifying
CAUTION:
Never attempt to adjust the louvres manually.
Manual adjustment on the louvres can cause the unit to malfunction.
Position in the COOL or DRY mode for an extended period of time,
When the vertical adjustment louvre is positioned at the lowest
condensation may result.
1.19. COANDA AIR FLOW
Press the COANDA AIR FLOW button during cooling or dry operation
when you do not want to feel cold air.
Vertical adjustment louvre is set obliquely upward to deliver cool air to
the ceiling.
Press the button during heating operation. Vertical adjustment louvre
is set downward to deliver the warm air down to the floor and warm
you.
During operation, press the COANDA AIR FLOW button.
The remote control will display"
TO CANCEL
Press the COANDA AIR FLOW button again.
NOTE:
The COANDA AIR FLOW setting is cancelled When you press
TURBO button while COANDA AIR FLOW is set.
If you want AIR FLOW operation in FULL POWER mode, press
COANDA AIR FLOW button during FULL POWER operation.
Cooling
Can be changed Can be changed
between 18 and 32C between 18 and 32C
using remote control. using remote control.
The remote control will display"
The temperature display will go off.
The green FULL POWER lamp on.
The unit will light up.
TO CANCEL
Press the FULL POWER button again.
The FULL POWER operation will also be cancelled when the opera-
tion mode is changed, or when the unit is turned off.
The geen FULL POWER lamp on the unit will turn off
NOTE:
The air conditioner will operate at "Extra HIGH" fan speed for 5
2 – 9
"
Manual mode
Heating Dehumidifying
Automatic setting.
Can be changed
within 2C.
"