Initial Setup - Onkyo TX-RZ610 User Manual

> Specifications > Settings

Initial Setup

When you turn the unit on for the first time after purchasing
it, Initial Setup is automatically shown on the TV to enable
you to make settings required for startup using simple
operations following onscreen guidance.
Initial Setup
Language Select
English
Deutsch
Français
Español
Italiano
Nederlands
Svenska
Operation:
Select the item with the cursors of the remote controller
and press ENTER to confirm your selection. To return to
the previous screen, press .
To redo Initial Setup:
If you terminate the procedure on the way or want to
change a setting made during Initial Setup, press
remote controller, select "7. Miscellaneous" - "Initial Setup",
and press ENTER.
■ 1� AccuEQ Room Calibration
Place the supplied speaker setup microphone in the
listening position, measure the test tones emitted by the
speakers, then the unit automatically sets the optimum
volume level for each speaker, the crossover frequencies,
and the distance from the listening position. This also
automatically adjusts the equalizers for the speakers and
enables correction of distortion caused by the acoustic
environment of the room.
• Calibration takes several minutes to be completed.
22
> Listening Modes > Playback Function
The speakers emit the test tone at high volume during
measurement, so be careful of your surroundings. Keep
the room as quiet as possible during measurement. If
the measurement is interrupted, turn off the household
appliances.
1. Place the supplied speaker setup microphone in the
listening position, and connect to the SETUP MIC jack
on the main unit.
SETUP MIC
Exit
When putting the speaker setup microphone on a
tripod, refer to the illustration when putting it in place.
2. Select the connected speaker configuration.
on the AccuEQ Room Calibration
Select how many speakers you have.
The image on the screen changes as you choose the
number of channels in "Speaker Channels", so refer to it
when performing the settings. Select 5.1.2ch, etc., when
using a height speaker.
Also use this screen to select whether you have
connected a subwoofer and to select the type of height
Speaker Channels 7.1 ch < >
Subwoofer Yes
Height Speaker ---
Zone Speaker No
Bi-Amp No
Next
> Basic Manual
Troubleshooting | Appendix
speaker, etc.
• If you have connected a subwoofer, check the power
and volume of the subwoofer. The low frequencies
played by the subwoofer may not be discernible, so
set its volume to at least halfway.
3. Test tones are emitted by the speakers, and firstly the
unit detects the speakers connected and the noise in
the environment.
4. After the results of the above measurements are
displayed, select "Next", press ENTER on the remote
controller, and the test tones are emitted again, and the
unit automatically makes settings such as the optimum
volume level and the crossover frequency.
5. When the measurement is completed, the measurement
result is displayed.
Press the cursors / on the remote controller to
check the settings. Press ENTER when "Save" is
selected to save the settings.
AccuEQ Room Calibration
Review Crossover
Subwoofer : Yes
Front : 100Hz
Center : 100Hz
Surround : 100Hz
Surround Back : 100Hz
Height : ---
Save
Cancel
6. Select whether to enable or disable the equalizer
function that corrects for distortion caused by the
acoustic environment of the room.
AccuEQ Room Calibration
To enable equalizer for each speakers, select "On".
Please select "All Channels", if you have same speakers for all
channels. Please select "Except Front Left / Right", if front
speakers are larger than other speakers.
On (All Channels)
On (Except Front Left / Right)
Off
Next