Renault Master Handbook page 217

TYRE INFLATION KIT
12
19
18
17
16
15
Inflation kit E
Depending on the vehicle, in the event
of a puncture, use the inflation kit loca-
ted underneath the driver's seat.
Before using this kit, park
the vehicle at a sufficient
distance from traffic, switch
on the hazard warning
lights, apply the handbrake, ask all
passengers to leave the vehicle and
keep them away from traffic.
(5/6)
With the engine running and the par-
E
king brake applied,
– unroll the hose from the container;
– connect the compressor hose 14 to
the container's inlet 19;
13
– depending on the vehicle, connect
the container 19 to the compressor
from the container recess 18;
– unscrew the valve cap on the rele-
vant wheel and screw on the contai-
ner's inflation adapter 12;
14
– disconnect any accessories previ-
ously connected to the vehicle's ac-
cessories sockets;
– adapter 13 must be connected to
the vehicle accessories socket;
– press switch 15 to inflate the tyre to
the recommended pressure (please
refer to the information in the section
on "Tyre pressure");
– after a maximum of 15 minutes, stop
inflating and read the pressure (on
pressure gauge 16).
Note: while the container is emp-
tying (approximately 30 seconds),
the pressure gauge 16 will briefly in-
dicate a pressure of up to 6 bar. The
pressure will then drop.
– adjust the pressure: to increase
it, continue inflation with the kit; to
reduce it, press button 17.
If a minimum pressure of 1.8 bar is
not reached after 15 minutes, repair
is not possible; do not drive the vehi-
cle but contact an approved dealer.
If the vehicle is parked on
the hard shoulder, you must
warn other road users of
your vehicle's presence
with a warning triangle or with other
devices as per the legislation ap-
plying to the country you are in.
5.9