Closing The Door; Replacing The Lamp - AEG SCT71809S0 User Manual

Problem
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.

7.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Possible cause
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The FROSTMATIC or
COOLMATIC function is
switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
There is no cold air circula-
tion in the appliance.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

7.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
Solution
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
15