16-106 ELECTRICAL SYSTEM
Switches and Sensors
Speed Sensor Installation
Apply a non-parmanent locking agent to the speed sensor
mounting bolt [A].
Install the speed sensor [B] to the inner engine sprocket
Torque - Speed Sensor Mounting Bolt: 6.9 N·m (0.70 kgf·m,
Install the engine sprocket cover (see Engine Sprocket
Cover Installation in the Final Drive chapter).
Connect the speed sensor lead connector.
Install the fuel tank (see Fuel Tank Installation in the Fuel
System (DFI) chapter).
Confirm that the drain hose and clamp are installed se-
curely and run the hose correctly (see Cable, Wire, and
Hose Routing section in the Appendix chapter).
Speed Sensor Inspection
Remove the speed sensor (see Speed Sensor Removal).
Connect the speed sensor connector [A] with the battery
[B], 10 kΩ resistor [C] and hand tester [D] as shown in the
Set the tester to the DC 25 V range.
Special Tool - Hand Tester: 57001-1394
Trace [A] of the speed sensor surface with the screw-
Then the tester indicator should flick [B].
If the tester indicator does not flick, replace the speed
Oxygen Sensor Removal (Equipped Models)
Never drop the sensor especially on a hard surface.
Such a shock to the sensor can damage it.
Do not pull strongly, twist, or bend the oxygen sen-
sor lead. This may cause the wiring open.
Clear the oxygen sensor lead from the clamp [A].
Disconnect the oxygen sensor lead connector [B].