16-98 ELECTRICAL SYSTEM
Immobilizer System (Equipped Models)
The first ignition key is successfully registered in the ECU.
The warning indicator light (LED) and the immobilizer
warning symbol [A] blink 1 time and stops for 1 second
and the repeats this cycle to indicate successful registra-
tion of the first ignition key.
Turn to OFF the ignition switch and remove the first igni-
The immobilizer warning symbol [B] disappears.
The warning indicator light (LED) [A] then blinks for 15
seconds; it means the ECU is in the registration mode.
After 15 seconds, the ECU ends the registration mode
and stops blinking the warning indicator light (LED).
Insert and turn on the next key between 15 seconds that
the ECU is in the registration mode.
When a registration mode was ended, do the registered
ignition key verification procedure over again to restart
it. This applies to all ignition key registration.
Insert the second ignition key into the ignition switch, and
turn it to ON.
Keep other ignition keys away from the immobilizer an-
If there is any problem in the registration, the warning
indicator light (LED) and the immobilizer warning symbol
[A] blink to display the collation error.
Immobilizer Amplifier Failure
When Registered Ignition Key is Inserted.