16-90 ELECTRICAL SYSTEM
Immobilizer System (Equipped Models)
Verified
○
The warning indicator light (LED) and the immobilizer
warning symbol [A] blink to display the ECU is in the
registration mode (go to the next step).
Not Verified
○
The warning indicator light (LED) and the immobilizer
warning symbol [A] blink to display the collation error.
Immobilizer Amplifier Failure
Registered Ignition Key Collation Error
•
Turn to OFF the ignition switch and remove the new igni-
tion key 1.
○
The immobilizer warning symbol [B] disappears.
○
The warning indicator light (LED) [A] then blinks for 15
seconds; it means the ECU is in the registration mode.
○
After 15 seconds, the ECU ends the registration mode
and stops blinking the warning indicator light (LED).
•
Disconnect the antenna lead connector of the current ig-
nition switch and connect the antenna lead connector of
the new ignition switch [A].
•
Insert the ignition key 1 [B] again into the new ignition
switch, and turn it to ON.
○
Insert and turn on the ignition key within 15 seconds that
the ECU is in the registration mode.
○
When a registration mode was ended, do the registered
ignition key verification procedure over again to restart
it. This applies to all ignition key registration.
○
Keep other ignition keys away from the immobilizer an-
tenna.
NOTE
Comments to this Manuals
Latest comments: