Meter, Gauge, Indicator Unit
Check 16: Trip A/B Meter Check
Check the trip meter with the speedometer in the same
If value indicated in the trip meter is not added, replace
the meter unit.
Check that when the RESET button is pushed for more
than two seconds, the figure display turns to 0.0.
If the figure display does not indicate 0.0, replace the me-
Check 17: Tachometer Inspection
Connect the leads in the same circuit as Check 1.
The engine speed (rpm) equivalent to the input frequency
is indicated in the oscillator [A], if the square wave is input
into terminal .
Indicates approximately 4 000 rpm if the input frequency
is approximately 133.3 Hz.
If the meter function does not work, replace the meter
Disconnect the terminal .
Check that the tachometer needle [A] back to the mini-
mum (0) position.
If the meter unit does not work, replace the meter assem-
Fuel Level Sensor Line Self-Diagnosis Mode
Usually when the open or short of the fuel level sensor
circuit is detected, it becomes the Fuel Level Sensor
Line Self-Diagnosis Mode.
The all segments of the fuel gauge [A] in the display
(This function is Fuel Level Sensor Line
If the meter enters the self-diagnostic mode when the me-
ter is installed in the motorcycle, check the fuel level sen-
sor (see Fuel Level Sensor Inspection) and wiring.
If the fuel level sensor and wiring are good, replace the
ELECTRICAL SYSTEM 16-81