16-76 ELECTRICAL SYSTEM
Meter, Gauge, Indicator Unit
By pushing the RESET button, check that the hour and
minute display start flashing.
By pushing the MODE button, check that the hour and
minute display decide.
When both hour and minute display is flashing, by push-
ing the RESET button, check that the hour display start
flashing. This flashing returns the hour setting display.
If the display function does not work, replace the meter
If the terminal 15 disconnected when the clock is setting,
clock is set at time of that time.
Immobilizer Flashing Mode Inspection
Connect the leads in the same circuit as Check 1.
Disconnect the terminal .
Check that the warning indicator light (LED) [A] starts
flashing (Immobilizer Warning Indicator Light Flashing
Push the MODE [B] and RESET [C] buttons more than 2
second, within 20 seconds after the terminal  discon-
Check that the warning indicator light (LED) goes on one
second, and then the light goes off (Immobilizer Warning
Indicator Light No Flashing Mode).
For this inspection, be sure the battery is 12.2 V or
more. Immobilizer Warning Indicator Light Flashing
Mode does not work, when the battery voltage is less
than 12 ±0.2 V.
Connect the terminal  to the battery (+) terminal.
And then, disconnect the terminal .