Anti-Lock Brake System (Equipped Models)
Visually inspect the connector terminals [A].
Replace the ABS hydraulic unit or main harness if either
of the terminals are cracked, bent, or otherwise damaged.
If the ABS hydraulic unit connector is clogged with mud
or dust, blow it off with compressed air.
Front Wheel Rotation Sensor Removal
The wheel rotation sensor should be handled care-
fully, never struck sharply, as with a hammer, or al-
lowed to fall on a hard surface since the wheel rota-
tion sensor is precision made. Be careful not to get
water or mud on the wheel rotation sensor.
Do not try to disassemble or repair the wheel rota-
Upper Fairing (see Upper Fairing Removal in the Frame
Connector [A] (Disconnect)
Clear the sensor lead from the clamps [B].
Front Wheel Rotation Sensor [D]
Front Wheel Rotation Sensor Installation
Installation is the reverse of removal.
Replace the brake hose clamp with a new one
(ZX1000HB Early Model).
For ZX1000HB Late Model ∼, face the lock portion [A] of
the brake hose clamp backward.
Run the lead correctly (see Cable, Wire, and Hose Rout-
ing section in the Appendix chapter).