Cylinder Head Removal
Coolant (Drain, see Coolant Change in the Periodic
Camshafts (see Camshaft Removal)
Throttle Body Assy (see Throttle Body Assy Removal in
the Fuel System (DFI) chapter)
Exhaust Pipe (see Exhaust Pipe Removal)
Disconnect the water temperature sensor connector [A].
Water Hoses [C]
Timing Rotor (see Timing Rotor Removal in the Electrical
Front Camshaft Chain Guide Bolts [A]
Front Camshaft Chain Guide [B]
Rear Camshaft Chain Guide Bolt [C]
Rear Camshaft Chain Guide [D]
Lower Engine Bracket Bolts (Both Sides) [A]
Upper Engine Mounting Bolts (Left)
Upper Engine Mounting Bolts (Right) [B]
Upper Adjusting Collar Locknut [C]
Special Tool - Engine Mount Nut Wrench: 57001-1450
Upper Adjusting Collar [D]
Remove the M6 cylinder head bolts [A].
Loosen the M10 cylinder head bolts as shown sequence
[1 ∼ 10] in the figure, and remove them with washers.
Remove the cylinder head.
Cylinder Head Installation
The camshaft cap is machined with the cylinder head,
so if a new cylinder head is installed, use the cap that
is supplied with the new head.
ENGINE TOP END 5-27