Throttle Body Assy
Remove the throttle body assy [A] from the throttle body
Disconnect the injector connectors [B].
Remove the clamps [C].
After removing the throttle body assy, stuff pieces of lint
-free, clean cloth into the throttle body assy holders.
If dirt or dust is allowed to pass through into the
throttle body assy, the throttle may become stuck,
possibly causing accident.
If dirt gets into the engine, excessive engine wear
and possible engine damage will occur.
Throttle Body Assy Installation
Be sure to position the throttle body assy holder clamp in
original position (see Throttle Body Assy Holder Installa-
tion in the Engine Top End chapter).
Connect the injector connectors [A].
Install the throttle body assy to the throttle body assy hold-
Install the clamps [B].
Torque - Throttle Body Assy Holder Clamp Bolts: 2.9 N·m
(0.30 kgf·m, 26 in·lb)
Special Tool - Carburetor Drain Plug Wrench, Hex 3:
Apply a thin coat of grease to the throttle cable lower ends.
Fit the accelerator cable end [A] and the decelerator cable
end [B] into the throttle pulley.
The accelerator cable has a clamp [C].
Install the clamp securely.
Turn the throttle grip and make sure that the throttle pulley
moves smoothly and return by spring force.
Run the leads and hoses correctly (see Cable, Wire, and
Hose Routing section in the Appendix chapter).
Throttle Grip Free Play (see Throttle Control System In-
spection in the Periodic Maintenance chapter)
Idle Speed (see Idle Speed Adjustment in the Periodic
FUEL SYSTEM (DFI) 3-127