Replacing The Heat-Sink Assembly; Procedure; Post-Requisites - Dell INSPIRON 15 5500 Service Manual

Replacing the heat-sink
assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
CAUTION: Incorrect alignment of the heat sink can damage the
system board and processor.
NOTE: The original thermal grease can be reused if the original system
board and fan are reinstalled together. If either the system board or the
fan is replaced, use the thermal pad provided in the kit to ensure that
thermal conductivity is achieved.

Procedure

1 Place the heat-sink assembly on the system board.
2 Align the screw holes on the heat-sink assembly with the screw holes on
the system board.
3 Replace the screws that secure the heat-sink assembly to the system
board.
4 In sequential order (indicated on the heat-sink assembly), tighten the
captive screws that secure the heat-sink assembly to the system board.
5 Connect the fan cable to the system board.

Post-requisites

1 Replace the system-board
2 Replace the wireless
3 Replace the memory
4 Replace the battery.
5 Replace the hard
6 Replace the I/O
7 Replace the base
64
computer. After working inside your
assembly.
card.
modules.
drive.
board.
cover.
After working inside your