Installation Instructions This Unit Is Intended For Installation In Vehicles With 12 Volt Negative Ground Electrical Systems Only. Kit Contents: PRO 9845 Control Module (2) - Two Button Transmitters 4 Channel Code Learning Receiver On Board Antenna (1) - Multi Pin Input/Output Harness...
Page 2
WHITE Wire: Positive Parking Light Flash Wire This wire is designed to output a +12VDC positive light flash output, driven by the PRO 9845's internal relay, to be connected directly to the vehicle's positive parking light circuit. Once the wire is located, confirm that all the...
Page 3
BLACK Wire: Main System Ground This is one of the most important wires of the PRO 9845 installation. It must be connected properly to a solid chassis ground. Special care must be taken to locate a clean metal part of the chassis as an attachment point for this wire.
Page 4
Polarity" systems found on many Ford and Chrysler vehicles, either the optional Power Door Lock Interface (Model # AS-9159), or the equivalent 30A automotive relays must be used. Contact the Audiovox Technical Support Department for additional information on the proper wiring of these circuits.
Green/White wires to the PRO 9845 unit and plug the white 3PIN connector into the mating white three pin connector shell of the PRO 9845 control module. Do not force the connector, it will only plug in one way. TRANSMITTER PROGRAMMING:...
Page 6
2 Chirps. This signifies that you have changed the programming to Chirps OFF. Please follow the programming procedure on the next page, and refer to the list of the Programmable Features above when programming the PRO 9845.
COMPLETING THE INSTALLATION: After you have confirmed the operation of the PRO 9845, and tested any and all optional features of the system: 1. Mount the control module up and behind the dash securing it in place with cable ties or screws. Be certain that the chosen mounting location will not inhibit any of the controls of the vehicle.