Wcdma Rx Chain Activation For Manual Measurement - Nokia RM-627 Service Manual

Hide thumbs Also See for RM-627:
Table of Contents

Advertisement

RM-627
RF troubleshooting

WCDMA RX chain activation for manual measurement

Steps
1. In Phoenix, select Testing → WCDMA → Rx Control . The Phoenix Rx Control window opens.
Figure 21 Phoenix Rx Control window with sample settings (WCDMA band I)
2. Make settings for the band to be tested according to the following table:
Band to be tested
WCDMA I
WCDMA II
WCDMA VIII
3. Make the following general settings (the same values for all bands):
Setting
AGC Mode
AFC Algorithm
AFC DAC
4. Click Start to activate the settings.
If the settings are changed later on (for example, change of channel) you have to click Stop and Start
again.
Issue 1
Phoenix Channel
10700
9800
3013
Algorithm
OFF
1024
COMPANY CONFIDENTIAL
Copyright © 2010 Nokia. All rights reserved.
Signal generator to antenna
2141.0MHz
1961.0MHz
943.6MHz
Value
connector
Page 4 – 11

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents