Operation - Panasonic KX-TDA100 Installation Manual

4.1 Troubleshooting
4.1.3

Operation

PROBLEM
• When using the
speakerphone on an APT,
nothing is audible.
• When using the
speakerphone/monitor
mode with a DPT, nothing is
audible.
• The PT does not ring.
• During a power failure,
extensions connected to
ports 1 to 4 of MSLC16/
CSLC16/SLC16 and ports 1
to 2 of DHLC8/SLC8 cards
do not operate.
• Originating an outside call,
call transfer, or conference
cannot be performed.
• Cannot register the PS.
• PS becomes out of range.
• Cannot make calls using the
PS.
• Noise is frequent while using
the PS.
• Conversations disconnect
while using the PS.
172 Installation Manual
PROBABLE CAUSE
• The HANDSET/HEADSET
selector is set to the
"HEADSET" position.
• The "HEADSET" mode is
selected by Personal
Programming, "Handset/
Headset Selection".
• The ringer volume is off.
• A DPT or APT is connected
to the extension port.
• The dialing mode (tone or
pulse) is incorrect.
• The corresponding CO
button does not exist on the
PT.
• Wrong Personal
Identification Number (PIN)
is registered to the PS.
• CS is not connected
properly.
• CSIF card is not working.
• CS is not working.
• Location of CS is not good. •
• Access system of the PS is
not properly set.
• Call handover is not
working while using the PS.
• PS is out of CS coverage
area.
SOLUTION
• When the headset is not used, set the
HANDSET/HEADSET selector to the
"HANDSET" position.
• When the headset is not used, select
the "HANDSET" mode by Personal
Programming.
• Turn on the ringer volume.
• Disconnect the DPT or APT and
connect an SLT.
• Set the Tone/Pulse switch to the other
position.
• Program the CO button. Refer to "1.6.3
Flexible Buttons" in the Feature
Manual.
• Enter the PIN set to the Hybrid IP-PBX
into the PS.
• Make sure that the cable is connected
properly with correct pin assignments.
Also, make sure that the cable does not
make short circuits.
• Switch all DIP switches off.
• Install the CSIF card properly.
• Make sure that the cable is connected
properly with correct pin assignments.
Also, make sure that the cable does not
make short circuits.
• Switch all DIP switches off.
Locate the CS properly (refer to "2.8.5
Site Survey" ).
• Change the access system setting of
the PS to the appropriate system or
automatic.
• Locate the CS properly (refer to "2.8.5
Site Survey" ).