Important Safety Instructions For Use Of The Cut-Off Machine; Double Insulation For Safer Operation - Hitachi CC 12Y Instruction Manual

17. Carefully handle power tools.
Should a power tool be dropped or struck against
hard materials inadvertently, it may be deformed,
cracked, or damaged.
18. Do not wipe plastic parts with solvent.
Solvents such as gasoline, thinner benzine, carbon
tetrachloride, and alcohol may damage and crack
plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened
with soapy water and dry thoroughly.
19. ALWAYS wear eye protection that meets the
requirement of the latest revision of ANSI
Standard Z87.1.
20. ALWAYS wear a mask or respirator to protect
yourself from dust or potentially harmful particles
generated during the operation.
21. Keep the motor interior free of water.
22. Proceed with cutting operation when full speed
has been reached.
23. Do NOT apply excessive force.
24. Secure the workpiece and check that the
workpiece is properly supported. A workpiece
clamped with clamping devices or in a vice is
held more securely than by hand.
25. Take good care of the power tool and keep it
clean.
26. Store the wheels in the dry condition and keep
away from the wet or damp location.
27. Inspect the wheel before use, do not use
chipped, cracked or otherwise defective
products.
28. Defi nitions for symbols used on this tool
V .............volts
Hz ...........hertz
A .............amperes
n .............rated speed
W ............watt
...........Class II Construction
---/min .....revolutions per minute
MAKE THEM AVAILABLE TO OTHER USERS
SAVE THESE INSTRUCTIONS
AND
AND
OWNERS OF THIS TOOL!
IMPORTANT SAFETY INSTRUCTIONS
FOR USE OF THE CUT-OFF MACHINE
WARNING
Death or serious bodily injury could result from
improper or unsafe use of the cut-off machine.
To avoid these risks, follow these basic safety
instructions:
1. Always use proper guard with grinding wheel.
A guard protects operator from broken wheel
fragments.
2. Accessories must be rated for at least the speed
recommended on the tool warning label.
Wheels and other accessories running over rated
speed can fl y apart and cause injury.
DOUBLE INSULATION FOR SAFER
OPERATION
To ensure safer operation of this power tool, HITACHI has
adopted a double insulation design. "Double insulation"
means that two physically separated insulation systems
have been used to insulate the electrically conductive
materials connected to the power supply from the outer
frame handled by the operator. Therefore, either the
symbol " " or the words "Double insulation" appear on
the power tool or on the nameplate.
Although this system has no external grounding, you must
still follow the normal electrical safety precautions given in
this Instruction Manual, including not using the power tool
in wet environments.
To keep the double insulation system effective, follow
these precautions:
○ Only HITACHI AUTHORIZED SERVICE CENTER
should disassemble or assemble this power tool, and
only genuine HITACHI replacement parts should be
installed.
○ Clean the exterior of the power tool only with a soft
cloth moistened with soapy water, and dry thoroughly.
Never use solvents, gasoline or thinners on plastic
components; otherwise the plastic may dissolve.
English
7