How To Read - Panasonic PanaXSeries MN1030 Series User Manual

• How to read

1.3.4 Environment Settings
Before using the Cross-Assembler, verify or change the following two files.
CONFIG.SYS
If FILES and BUFFERS specifications do not already exist in CONFIG.SYS, then you must add them.
If they do already exist, then check their settings, and change them if necessary.
FILES=20
BUFFERS=20
NOTE:
Terminology:
• Heading
Chapter titles are shown here on each page, so the reader can get a quick idea of contents while
flipping through the pages.
Program example
•
These are actual examples of command options and instructions used by the assembler. First-
time users should refer to these examples when trying to use the assembler.
• Usage note
These give important information. Usage note provide cautions about usage, so they should
always be read.
Supplementary explanation
•
These are hints and terminology definitions that can help the reader use the assembler.
Be sure to make these settings. If the assembler is started without them, then
the error message "bad tmpbss(w)" will be output and processing will stop. This
means that the number of files that can be opened simultaneously is insufficient.
CONFIG.SYS
This is the file that sets the MS-DOS operating environment. FILES specifies
the number of files that can be read and written simultaneously.
BUFFERS specifies the size of memory used for reading/writing disks.
Chapter 1 Installation
Supplementary explanation
Installing PC Version 14
Heading
Program example
Usage note
<About This Manual 2 >