Table of Contents
Advertisement
Chapter 13 Error Messages
13.2.1 Warning Messages
2001
Operand error
An operand is of the wrong type.
Check the number and types of operands,
2002
Illegal operand value
An operand does not have an acceptable value.
Change the value of the operand.
2003
Define symbol multiple defined.
The same symbol is defined twice.
Change the identifier after the #define or use the #undef control statement.
2004
Define symbol not defined.
The identifier specified in an #undef statement has not been defined.
Check the spelling of the identifier.
2005
Ignore RADIX.
If an expression uses extended language syntax, the assembler ignores the radix directive.
Delete the radix directive.
2006
Change RADIX equal 10.
An expression using extended language syntax does not use a radix of 10.
Use the radix directive to change the radix to 10.
2007
Line too long.
A source statement exceeds the length limit.
Edit the source statement so that its length is within the limit.
2008
Macro name multiple defined.
Multiple macros share the same name.
Change the names of the extra macros.
2009
The usage of a series of instructions may be restricted in MN1030/
103S series
The usage of a series of instructions may be restricted in MN1030 series. Careful operation is
needed as some operations are not guaranteed.
Refer to the notes, attentions or warnings written in MN1030/MN103S Series Instruction Manual
for 32-bit and ensure that the expected operation is guaranteed. If it is not guaranteed, modify the
program. See Chapter 3, "How to Use Instructions" in the Instruction Manual 3rd version (or later)
or "Chapter 5 section 2, "Programming Notes" in the former versions.
2010
The usage of this instruction may be restricted in MN1030/103S
series.
The usage of a series of instructions may be restricted in MN1030 series hardware. Careful
operation is needed as some operations are not guaranteed.
Refer to the notes, attentions or warnings written in MN1030/MN103S Series Instruction Manual
for 32-bit and ensure that the expected operation is guaranteed. If it is not guaranteed, modify the
program. See Chapter 3, "How to Use Instructions" in the Instruction Manual 3rd version (or later)
or "Chapter 5 section 2, "Programming Notes" in the former versions.
252 Assembler Errors
Advertisement
Table of Contents
