Setup Utility - Panasonic CF-W2 Series XP Operating Instructions Manual

Setup Utility

Running the Setup Utility
The Setup Utility sets the computer's boot-up operating environment, i.e. passwords,
startup drive, etc. The following six menu items are available:
[Information], [Main], [Advanced], [Security], [Boot], [Exit]
1
Turn on or restart the computer.
2
F2
Press the
soon after the computer begins the startup procedure.
When the password is set, the screen shown at left will be displayed. Enter
your password, and press the Enter key.
When inputting the Supervisor Password
You can register all items of the Setup Utility.
When inputting the User Password
On the [Advanced] and the [Boot] menu:
• You can view the settings, but cannot change it.
On the [Security] menu:
• [Clear registered SD card], [Set Supervisor Password] and [Hard
Disk Lock] will not be displayed.
• [Password on boot], [SD Startup], [SD Setting Method], [Setup Utility
Prompt], [Boot First Menu] and [User Password Protection] will be
displayed, but cannot be set.
• The User Password can be changed only when [User Password Pro-
tection] has been set to [No Protection]. The User Password cannot
be deleted.
On the [Exit] menu:
• [Get Default Values] option will not be displayed.
The F9 key does not work.
NOTE
Cannot display the Setup Utility screen in simultaneous display.
By pressing the Fn+F3 key, display destinations can be changed either exter-
nal display or the internal LCD.
When [Password on boot] in the Setup Utility is set to [Disable]:
• When the computer is started up, entering a password is not necessary.
• When the Setup Utility is started up:
The password becomes necessary. This alternative can prevent the contents
of the Setup Utility from being changed.
If you fail to press the F2 key at the right moment, the Setup Utility will not start
up. In this case, let the computer fully boot up, and then perform a shutdown or
restart from Windows.
To close the Setup Utility:
A Press the Esc key.
B Select the exiting method from the [Exit] menu and press the Enter key.
C Select [Yes] and then press the Enter key.
key while [Panasonic] boot screen is displayed
31