Panasonic CF-30 Operating Instructions Manual page 23

12 Turn on the computer, and press
played.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
13 Press .
F9
At the confi rmation message, select [Yes] and then press Enter .
The Setup Utility settings excluding the password(s) will return to the default values.
14 Select the [Exit] menu and then select [Save Current Values], then press
At the confi rmation message, select [Yes] and press Enter .
15 Turn the computer off by using the power switch.
If additional instructions are included with the computer, be sure to read them. It may be necessary to per-
form additional operations during the following procedure.
16 Perform the fi rst-time operation (
17 Start the Setup Utility and change the settings as necessary.
To change the drive letter of hard disk or CD/DVD drive
NOTE
Drive letters can be changed only when two or more partitions have been created on the hard disk drive.
The name of the C: drive cannot be changed.
Change the drive letters before installing applications.
A Click [start] - [Control Panel] - [Performance and Maintenance] - [Administrative Tools], and double-click [Com-
puter Management].
B Click [Disk Management] from [Storage].
C Right-click the hard disk partition or the CD/DVD drive name, and click [Change Drive Letter and Paths...].
D Click [Change...].
E Click [Assign the following drive letter] and the new drive letter, and then click [OK].
At the confi rmation message, click [Yes].
several times while [Panasonic] boot screen is dis-
F2
page 13).
.
Enter
23