GE JEB100B Use And Care Manual page 30

r
PROBLEM
OVEN WILL NOT
COME ON
CONTROL PANEL
LIGHTED, YET OVEN
WILL NOT START
ON DISPLAY
"Error" APPEARS
ON DISPLAY
Dimming oven light and change in blower sound may
occur while operating at power levels other than high.
Dull, thumping sound while oven is operating.
Some TV-Radio interference might be noticed
while using your microwave oven. It's similar to
the interference caused by other small appliances
and does not indicate a problem with your oven.
If you need more help...call, toll free: GE Answer Center"/ 800.626.2000/ consumer information service
30
QUESTIONS?
USE THIS PROBLEM SOLVER
A fuse in your home may be blown or the circuit breaker tripped. Replace fuse or
reset circuit breaker.
circuit breaker to the off position. Wait 30 seconds. Reset the circuit breaker
to the on position.
. Door not securely closed.
START pad must be touched after entering cooking selection.
Another selection entered already in oven and CLEAWO~ pad not touched
to cancel it.
START pad,
Temperature probe not inserted properly or not being used during Auto Roast or
after setting temperature cooking programs.
have entered a code number after touching AUTO COOK, AUTO
Make sure you
Temperature probe is missing or not plugged in securely when using cooking
functions that measure food temperature.
During Auto Cook, Auto Reheat or Popcorn program, the door was opened before
steam could be detected, or steam was not detected in maximum time.
Nosteamwasdetectedby sensorwithin4 minutes andlOsecondsafterstartof
Popcorn program.
All these things are normal with your microwave oven:
Steam or vapor escaping from around the door.
Light reflection around door or outer case.
During cooking you will hear "cracking" and
"popping" noises which are nothing more than
normal expansion of the oven.
At the end of microwave cycles you will hear a
slight thump. This is normal.
COOK