Before Reading These Instructions - Panasonic CQ-C7703N Operating Instructions Manual

Before Reading These Instructions

The equalizer curve is selectable from among preset 6
Caution
types (FLAT, ROCK, POP, VOCAL, JAZZ, and CLUB)
depending on your listening category.
Be sure to select OFF when your car has no
Note: SQ is not changeable when SRS WOW is enabled.
ACC position in the ignition switch. Failure
to do this could cause the battery to go
(a page 18)
dead.
SQ changeover
The SQ category is changed every time [SQ] (SOUND Operating
QUALITY) is pressed.
Instructions
Note: Setting of SQ, bass/treble and volume are
influenced one another. If the influence mentioned above (YEFM285769)
causes distortion to the audio signal, readjust bass/treble
or volume. (a
The following functions are activated when the Security
Function is ON.
The security indicator lights up when removing the
¡
SQ is adjustable in accordance with your taste.
face plate.
1
POWER
SOURCE
Hold down [SQ] (SOUND QUALITY) for 2
SRC SRC SRC
SET
BAND BAND BAND
1 1
sec. or more when SRS WOW is disabled. RANDOM
4 4
7 7
TUNE
# #
NUMBER
2
Press [BAND].
The targeted SQ preset appears.
Remote Control Unit
3
(including a battery) Adjust each band.
(CR2025)
(EUR7641010)
You may need to set the following depending on the
Band: 60, 160, 400, 1 k, 3 k, 6 k, 16 k (Hz)
devices to be connected.
[]][[]: Band selection
[}][{]: Level up/down
Using Subwoofer
4
Press [BAND] to determine the adjust-
Subwoofer level adjustment
¡
¡ Subwoofer low pass filter
ment.
The screen of Step 1 appears again.
Lock Cancel Plate
Notes:
The rear speaker can be used as a substitutional
¡ subwoofer when a subwoofer is not connected. Adjust the clock when "NO CT" appears on the dis-
play.
Holding down [MUTE] (SBC-SW) for 2 sec.
¡ When a broadcast of FM Radio Data System is
or more toggles SBC-SW on and off.
received, the clock is put right automatically by the
Clock Time service.
Off (default)
1
Notes:
Press [MENU] to display the menu
¡ The number in parenthesis underneath each accessory part name is the part number for maintenance and service.
display.
¡ Accessories and their parts numbers are subject to modification without prior notice due to improvements.
For using the remote control, hold down [SEL]
¡ Mounting Collar and Trim Plate are mounted on the main unit at shipment.
(MENU) for 2 sec. or more.
2
Press []] or [[] to display the
DISPLAY menu.
Notes:
3
Press [
¡ If ON is selected, the settings of subwoofer level
adjustment and subwoofer low pass filter are activat-
4
Press [BAND] (SET) to confirm the
ed. (a page 30)
display.
¡ SBC-SW is not changeable when SRS WOW is
enabled. (a
Downloaded from Caradio-Manual.com Manuals Downloaded from Caradio-Manual.com Manuals Downloaded from Caradio-Manual.com Manuals
XXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
OO-OOOOO
OFF
System Upgrade
ACC
Guidebook
IGN
(YEFM262697)
Q'ty: 1
page 30)
(a page 31)
MENU
SEL SEL SEL
VOL VOL VOL
MUTE MUTE MUTE
2 2 3 3
SCAN REPEAT
5 5 6 6
8 8 9 9
TUNE
0 0
DISP DISP
CAR AUDIO
Power Connector
Security Indicator
(YGAJ021010)
Q'ty: 1
(a page 30)
(a page 30)
Mounting Bolt
(5 mmø)
(a page 20)
{
] to select "CLOCK ADJ".
page 16)
For a ACC-equipped car, select ON.
following functions are available. (default: off)
XXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
¡ The power is turned on automatically when inserting a
OO-OOOOO
disc.
The clock can be displayed even if the power is off.
¡
(a page 15)
Installation
Instructions
(YEFM294135)
(YEFM294136)
(YEFM294137)
Q'ty: 1
¡ The alarm sounds and the message appears on the
screen to warn you to remove the face plate at ACC
off. (The above phenomenon occurs when the ACC
setting of the unit is set to ON at the ignition key is at
the ACC off position or when the ACC setting of the
unit is set to OFF at the power of the unit is off)
5
Press [D] (DISP: DISPLAY).
Mounting Collar
The regular screen appears again. "USER" appears in
the category name after adjustment.
(YEFX0217222)
Note: If you hold down [BAND] for 2 sec. or more
Q'ty: 1
on the SQ call-up screen, the presetting that is called
up can be turned into the default.
Connecting an AV device (TV,VTR)
Only for CQ-C7703N
If you connect TV to AUX1 terminal, set the AUX setting
to TV. (a page 34)
ISO Antenna
Adapter
5
Adjust the setting value.
(YEP0FZ5711)
[[]
: Adjusting minutes
[]]
: Adjusting hours
}
[ ]
: Forward
{
[ ]
: Backward
6
Press [BAND] (SET) to confirm the
On
adjustment.
7
Press [MENU].
For using the remote control, hold down [SEL]
(MENU) for 2 sec. or more.
CQ-C7703N/C7303N CQ-C7703N/C7303N CQ-C7703N/C7303N
(a page 31) The
PAN EUROPEAN
GARANTEE
(Warranty Card)
Q'ty: 1 set
Lights when SQ is activated.
Trim Plate
(YEFC051013)
Q'ty: 1
Removable Face
Plate Case
(YEFA134150)
Q'ty: 1 set
Lights when SBC-SW is activated.
Q'ty: 1
Q'ty: 1
Q'ty: 1
17 11 5