Components (Fig. 1) - Black & Decker D6138 Original Instructions Manual

(original instructions)
ENG LI S H
EQUIPMENT.
WARNING: Always wear proper
personal hearing protection that
conforms to ANSI S12.6 (S3.19)
during use. Under some conditions and
duration of use, noise from this product
may contribute to hearing loss.
WARNING: Some dust created by
power sanding, sawing, grinding,
drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects, or other
reproductive harm. Some examples of
these chemicals are:
• lead from lead-base d paints,
• crystalline silica from bricks and cement and
other masonry products, and
• chromiu arsenicand
treated lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
• Avoid prolonged contact with dust from
power sanding, sawing, grinding, drilling
and other construction activities. Wear
protective clothing and wash exposed
areas with soap and water. Allowing dust
to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful
chemicals.
WARNING:Use of this tool can
generate and/or disperse dust, which
may cause serious and permanent
respiratory or other injury. Always
use NIOSH/OSHA approved respiratory
protectionappropriate for the dust
exposure. Direct particles away from
face and body.
CAUTION: Use extra care when
working into a corner because a
sudden, sharp movement of the polisher
may be experienced when the wheel or
other accessory contacts a secondary
surface or a surface edge.
• The label on yo
following symbols. The symbols and their
definitionsareas follows:
8
m from chemically-
ur tool may include the
Save These Instructions
Motor
Your Black&Decker tool is powered by a D
built motor. Be sure your power supply agrees with
the nameplate marking. Voltage decrease of more
than 10% will cause loss of power and overheating.
Black&Decker tools are factory tested; if this tool
does not operate, check power supply.
Components (fig. 1)
WARNING: Never modify the power
tool or any part of it. Damage or personal
injury could result.
A. Speed control wheel
C. Variable speed trigger switch
D. Brush inspection cap
E. Spindle lock button
F. Auxiliary handle
G. Trigger locking button
I. Spindle
M. Clamp washer
O. Backing pad
N. Polishing pad
R. Sanding disc
INTENDED USE
The D6138 heavy-duty polishers are designed
for professional use at various work sites (i.e.,
construction sites). Do not use under humid
conditions or in presence of flammable liquids or
gases.
The D6138 heavy-duty polishers are professional
power tools. Do not let children come into contact
with the tool. Supervision is required when
inexperienced operators use this tool.
Auxiliary handle (fig. 1)
An auxiliary handle (F) is furnished with your tool
and can be installed on either side of the gear case.
This handle should be used at all times to maintain
complete control of the tool.
Variable Speed Trigger Switch (fig. 1)
WALT-
E