Canon iPF685 User Manual page 287

Hide thumbs Also See for iPF685:
Table of Contents

Advertisement

iPF685
C
Between Pages
You can set the time to wait after printing 1 document page until ejecting the paper. Since waiting time is required
for ink to dry before a roll is cut, you can deliver paper in the Output Stacker with the ink dried even if Cutting
Mode is set to Automatic.
Setting Item
Printer Default
None
30 sec. / 1 min. / 3 min. / 5 min. / 10
min. / 30 min. / 60 min.
D
Between Scans
You can set the time to wait after printing 1 line on a page until printing the next line. Set this to avoid bleeding or
color unevenness such as when bleeding occurs on a page or when color unevenness occurs during borderless
printing.
Setting Item
Printer Default
None
1 sec. / 3 sec. / 5 sec. / 7 sec. / 9
sec.
E
Roll Paper Margin for Safety
You can specify the length of a margin on the leading edge of paper to ensure that paper susceptible to curling is held
firmly against the Platen.
F
Near End Margin
Specify the length of the Near End Margin (the leading edge margin) of the roll, as needed.
Setting Item
Printer Default
3 mm (0.12 in)
20 mm (0.8 in)
G
Cut Speed
Select the speed of automatic cutting, as needed. You can adjust this setting if paper is not cut well when automatic
cutting is used.
Setting Item
Printer Default
High Speed
Standard
Low Speed
H
Automatic Cutting
Set whether to perform roll cutting automatically or print a cut line.
User's Guide
Downloaded from ManualsPrinter.com Manuals
The setting of the control panel of the printer is applied.
Paper is ejected immediately after printing completes.
Paper is ejected when the set time elapses after printing completes.
The setting of the control panel of the printer is applied.
The next line is printed immediately after a line is printed.
The next line is printed when the set time elapses after a line is printed.
* Increase the time according to the occurrence condition of bleeding or unevenness.
The setting of the control panel of the printer is applied.
The document is printed in the standard size.
* Select this when you do not have any problems in printing.
Select this when rubbing against the printhead occurs such as when using paper that tends
to curl.
The setting of the control panel of the printer is applied.
When the Standard setting does not result in a clean cut surface, select this.
Select this when you do not have any problems in automatic cutting.
This helps prevent adhesive from sticking to the cutter and keeps the cutter sharp if you se-
lect it when using adhesive paper.
Paper Detailed Settings Dialog Box
Details
Details
Details
Details
287

Advertisement

Table of Contents
loading

Table of Contents