Kenwood CK 230 FS Instructions For Use Manual page 17

ENAMELLED PARTS
All the enamelled parts must be cleaned with a sponge and soapy water or other non-
abrasive products.
Dry preferably with a soft cloth.
Acidic substances like lemon juice, tomato sauce, vinegar etc. can damage the enamel
if left in contact for too long.
STAINLESS STEEL, ALUMINIUM PARTS AND SILK-SCREEN PRINTED SURFACES
Clean using an appropriate product. Always dry thoroughly.
IMPORTANT: these parts must be cleaned very carefully to avoid scratching and abrasion.
You are advised to use a soft cloth and neutral soap.
CAUTION: Do not use abrasive substances or non-neutral detergents as these will
irreparably damage the surface.
GAS TAPS
In the event of operating faults in the gas taps, call the After Sales Service Department.
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains. When the oven is cool, unscrew and replace the
bulb with a new one suitable for high temperatures (300°C) having the following specifi-
cations: 230 V, 50 Hz, E14 and same power (check watt power as stamped in the bulb
itself) of the replaced bulb.
Note: Oven bulb replacement is not covered by your guarantee.
INSIDE OF OVEN
The oven should always be cleaned after use when it has cooled down. The cavity
should be cleaned using a mild detergent solution and warm water. Suitable proprietary
chemical cleaners may be used after first consulting with the manufacturers recommen-
dations and testing a small sample of the oven cavity.Abrasive cleaning agents or
scouring pads/cloths should not be used on the cavity surface.
NOTE: The manufacturers of this appliance will accept no responsibility for damage
caused by chemical or abrasive cleaning.
Let the oven cool down and pay special attention no to touch the hot heating ele-
ments inside the oven cavity.
17