Installation - Sony XAV-W650BT Operating Instructions Manual
Av center
Hide thumbs
Also See for XAV-W650BT:
- Operating instructions manual (120 pages) ,
- Service manual (30 pages) ,
- Operating instructions manual (92 pages)
Table of Contents
Advertisement
Available languages
Available languages
Cautions
It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
If airbags or any other shock-absorbing
equipment are in your car, contact the store
where you purchased this unit, or the car dealer,
before installation.
Note
Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.
Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 (not
supplied) is required before use.
1
To enable the steering wheel remote control, select
[General Settings] [User Defined] to make the
registration (page 19).
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable RC-SR1 (not
supplied)
Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper connection
may damage the unit.
Consulting the dealer or an experienced technician
for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [Steering
Control] in [General Settings] to [Preset] (page 19).
Using the rearview camera
Installation of the rearview camera (not supplied) is
required before use.
The image of a rearview camera connected to the
CAMERA IN terminal is displayed when:
the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
you press HOME, then touch [Rear Camera].
you press and hold DSPL then touch [Rear
Camera] if [SOURCE Key Func.] is set to [DSPL]
(page 20).
Installation
Mounting the unit in the dashboard
When mounting in a Japanese car, see “Mounting
the unit in a Japanese car” (page 37).
Mounting the unit with an installation kit
(not supplied)
Before installing, make sure the catches on both
sides of the bracket are bent inwards 3.5 mm (
5
/
32
in).
1
Position the bracket inside the
dashboard, then bend the claws outward
for a tight fit.
Larger than
Catch
182 mm (7
1
/
in)
4
Larger than
Bracket
111 mm (4
3
/
in)
8
2
Mount the unit onto the bracket.
Bracket
Note
If the catches are straight or bent outwards, the unit will
not be installed securely and may spring out.
Page 36
Advertisement
Chapters
Table of Contents
