Hang From The Wall To Use - Pioneer X-SMC11-k Operation Instructions Manual

Slim micro system
Hide thumbs Also See for X-SMC11-k:
Table of Contents

Advertisement

Connections

Hang from the wall to use

CAUTION
When hanging the unit from a wall, firmly screw the
wall hanging screws (sold separately) into the wall,
and confirm that the wall is capable of holding the
unit safely. If the materials or strength of the wall
cannot support the weight of the unit, then there is
the possibility of the unit falling off.
Do not connect the
iPad/iPad mini
unit is not compatible. Do not connect any device
that is not compatible. Please refer to page 15
for compatible or supported models.The
iPad mini may fall and cause injury, or tilt over and
cause damage to the device (especially around the
connector section).
Hang the unit from the wall only after all connections
(including USB and headphones) are completed. If redoing the
connections, take the unit off the wall first. When connections
are completed, connect the power cord to the AC outlet while
hanging the unit on the wall.
1
Screw the wall hanging screws into the
wall, putting them the specified attachment
measurement (154 mm) apart.
See Dimensions (Rear) on page 27.
Wall hanging screws
(commercially available)
154
Lock holes
Center line
2
Insert the wall hanging screws into the lock
holes.
Note
• Do not take your hands off the unit as the unit is still not
attached and may fall.
Immediately continue on to step 3.
to the dock. The
iPad/
2 mm to 3 mm
7 mm to 8 mm
Screw head
ø
ø
6.5 mm to
10 mm
Screw diameter
ø
4 mm
Suggested screw
diameter
(Please use screws that
match the wall strength
and wall materials)
3
Slide to the left, and drop down.
Please confirm that the unit is securely attached.
POWER ON
9 mm
Note
• When taking off the wall, move the unit in the opposite
direction from when mounting. Move up then slide to the
right.
• When attaching the unit to the wall, there is the
possibility of it falling depending on how it is attached.
Take due care to avoid any accidents.
• Select a location for the placement/installation of unit
that is sufficiently strong enough to hold the weight of
the unit. If you do not know the strength etc. of the wall,
then consult with a professional.
• The company bears no responsibility for accidents or
damages caused by inadequate installation/attachment,
incorrect use, modifications, natural disasters etc.
• Place all cables along the wall to prevent anyone from
tripping over them.
• When the unit is hanging from a wall, pay extra attention
to make sure your iPod/iPhone does not fall.
• Do not hold the unit by grabbing onto the iPod/iPhone
dock.
TIMER
SLEEP
TUNE
PUSH OPEN
17 mm
03
11
En

Advertisement

Table of Contents
loading

Table of Contents