Explanation Of General View; Specifications; Safety Instructions - Makita 2414nb Instruction Manual

ENGLISH (Original instructions)
1. Base
2. Bolt holes
3. Lock button / Lock-off button
4. Switch trigger
5. Screw
6. Spark guard
7. Socket wrench
8. Guide plate
9. Move
10. Hex bolts
11. Shaft lock
12. Safety guard

SPECIFICATIONS

Dimensions (L x W x H)
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
..... Read instruction manual.
.................. DOUBLE INSULATION
Intended use
The tool is intended for cutting in ferrous materials with
appropriate abrasive cut-off wheel. Follow all laws and
regulations regarding dust and work area health and
safety in your country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects to
the operation of other equipment. With a mains
impedance equal or less than 0.26 Ohms it can be

Explanation of general view

13. O-ring
14. Inner flange
15. Ring
16. Spindle
17. Cut-off wheel
18. Outer flange
19. Vise plate
20. Vise nut
21. Vise handle
22. Spacer block
23. Straight piece of wood (Spacer)
24. Over 45 mm long
Model
Wheel diameter
Hole diameter
-1
No load speed (min )
With under cover
With full type lower safety guard
With half type lower safety guard
With center cover/center cap
Safety class
END201-5
ENE007-3
ENF002-2
ENF100-1
25. Over 65 mm long
26. Over 190 mm long
27. Diameter of workpiece
28. Width of spacer block
29. Vise
30. Blocks
31. Under cover
32. Wing bolt
33. Limit mark
34. Screwdriver
35. Brush holder cap
500 mm x 280 mm x 620 mm
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.

SAFETY INSTRUCTIONS

WARNING! When using electric tools, basic
safety precautions, including the following, should
always be followed to reduce the risk of fire, electric
shock and personal injury. Read all these instructions
before operating this product and save these
instructions.
For safe operations:
1. Keep work area clean.
Cluttered areas and benches invite injuries.
2. Consider work area environment.
Do not expose power tools to rain. Do not use power
tools in damp or wet locations. Keep work area well lit.
Do not use power tools where there is risk to cause
fire or explosion.
3. Guard against electric shock.
Avoid body contact with earthed or grounded surfaces
(e.g. pipes, radiators, ranges, refrigerators).
4. Keep children away.
Do not let visitors touch the tool or extension cord. All
visitors should be kept away from work area.
5. Store idle tools.
2414NB
355 mm
25.4 mm
3,800
17.7 kg
16.2 kg
16.1 kg
/II
ENA001-2
5