Ipv6 In Ipv4 Tunnel - D-Link Wireless AC1200 User Manual

Section 3 - Configuration
You can configure the IPv6 connection to run in IPv4 Tunnel mode. IPv6 over IPv4 tunneling encapsulates IPv6 packets in IPv4 packets so that IPv6
packets can be sent over an IPv4 infrastructure.
Remote IPv4 Enter the Remote IPv4 address you will use.
Address:
Remote IPv6 Enter the Remote IPv6 address you will use.
Address:
Local IPv4 Displays the Local IPv4 address.
Address:
Local IPv6 Enter the Local IPv6 address you will use.
Address:
Subnet Prefix Enter the Subnet Prefix Length supplied by your ISP.
Length:
DNS Type: Select either Obtain DNS server address or Use the following DNS.
Primary DNS If you selected Use the following DNS above, enter the Primary
Server: DNS Server address.
Secondary DNS If you selected Use the following DNS above, enter the Secondary
Server: DNS Server address.
Enable DHCP-
Enable or disable prefix delegation services.
PD:
LAN IPv6 If you disabled DHCP-PD, enter the LAN (local) IPv6 address for the
Address:
router.
LAN IPv6 Link-
Displays the router's LAN IPv6 Link-Local Address.
Local Address:
D-Link DIR-850L User Manual

IPv6 in IPv4 Tunnel

45