Download Print this page

Installing The Tape Cassette; Authorised Tape - Brother 97OOPC User Manual

Hide thumbs Also See for 97OOPC:

Advertisement

Available languages

Available languages

ENGLISH

Installing the tape cassette

This section lists the types of tape that may be used with the printer and explains the procedures to
install the tape cassettes.

Authorised tape

The types of tape that may be used with the
printer are listed below.
TZ/TZe Tapes
Standard Laminated Tape
Standard Non-Laminated Tape
Strong Adhesive Tape - Laminated
Flexible ID tape - Laminated
Fabric Iron-On Tape - Non-Laminated
Security Tape - Laminated
Stencil Tape - Non-Laminated
HG/HGe Tapes
HG/HGe tapes enable three available
combinations of higher printing speed and
print resolutions. For details on high-speed
printing, refer to "Printing at a higher speed
or at a higher resolution" (→ P.32).
Installing the tape cassette
This section explains the procedure to install
the tape cassette.
1
Hold down the power button on the front
of the printer until the Power lamp is off.
Press the cover release button and open
2
the tape compartment cover.
Cover release button
3
Install the tape cassette.
Make sure that the end of the tape feeds
under the tape guide.
End of the tape
Toothed wheel
Tape guide
• If the ink ribbon is loose, use your
finger to wind the toothed wheel in the
direction of the arrow on the cassette.
4
Close the tape compartment cover and
press the power button on the front of
printer.
5
Press the Feed/Cut button to remove the
tape slack.
Note
You can only remove the tape cassette
when the roller assembly of the printer
has been released. It will be released
automatically if you press the power
button on the front of the printer or if no
additional operation is performed within
10 minutes after printing a label.
15

Advertisement

loading