Introduction Of Related Software And Its Applications; Ptp Drive Software Package; Modbus Master Drive Software Package; Modbus Slave Drive Software Package - Siemens SIMATIC S7 CP340 Programming Manual

2 Introduction of related software and its applications

Introduction of related software and its
2
applications
2.1 STEP7
STEP7 programming software is used to write PLC program, and it shall be
purchased from Siemens. All procedure codes in this document are written with
STEP7 V5.4 SP4.
2.2

PtP drive software package

PtP Param V5.1 is the drive software package for CP340/CP341/CP440/CP441,
and parameters may only be distributed to the serial communication module and
the function block necessary for communication programming may only be
integrated in STEP7 after this drive software package is installed. This drive will be
provided when the module is purchased, and it may also be downloaded through
the following linkage. The updated software version is PtP Param V5.1 SP11 at
present. http://support.automation.siemens.com/WW/view/en/27013524
2.3

MODBUS Master drive software package

This drive software package shall be installed when CP341 or CP441-2 is used in
MODBUS master, but PtP Param V5.1 drive program software package shall be
installed earlier. This drive software package may be purchased when purchasing
MODBUS Dongle or be downloaded through the following link:
MODBUS Master drive (RTU) software package:
http://support.automation.siemens.com/WW/view/en/27774018
MODBUS Master drive (ASCII) software package:
http://support.automation.siemens.com/WW/view/en/25356060
2.4

MODBUS Slave drive software package

This drive software package shall be installed when CP341 or CP441-2 is used in
MODBUS slave, but PtP Param V5.1 drive program software package shall be
installed earlier. This drive software package may be purchased when purchasing
MODBUS Dongle or be downloaded through the following link:
MODBUS Slave drive (RTU) software package:
http://support.automation.siemens.com/WW/view/en/27774276
MODBUS Slave drive (ASCII) software package:
http://support.automation.siemens.com/WW/view/en/25356060
2.5 ModScan32 / ModSlave
This is software provided by third party and may be downloaded from the Internet.
ModScan32 may be used to emulate MODBUS Master to test its communication
with MODBUS Slave. ModSlave may be used to emulate MODBUS Slave to test
its communication with MODBUS Master.
CP340/CP341/CP440/CP441 Communication and Programming
Entry-ID: 88867653, V1.0, 02/2014
5