New And Changed Information; New Information For Firmware Release 11.0; Phone Setup; Adjust The Handset Rest - Cisco 7811 User Manual

New and Changed Information

To use the phone, the phone needs to be connected to a network and configured to connect to a call control
system. The phones support many functions and features, depending on the call control system. Your phone
might not have all functions available, based on the way your administrator has set up the phone.
New and Changed Information

New Information for Firmware Release 11.0

This User Guide has been streamlined and restructured to improve the customer experience.
Table 2: Cisco IP Phone 7800 User Guide revisions for Firmware Release 11.0.
Revision
Added the following section for Problem Report Tool
support
Revised the following sections for cBarge and Barge
Revised the following sections for Do Not
Disturb(DND)
Added support for WebEx sign-in

Phone Setup

Typically, your administrator sets up your phone and connects it to the network. If your phone is not setup
and connected, contact your administrator for instructions.

Adjust the Handset Rest

If your phone is wall-mounted or if the handset slips out of the cradle too easily, you may need to adjust the
handset rest to ensure that the receiver does not slip out of the cradle.
Cisco IP Phone 7800 Series User Guide
2
Updated Section
Report All Phone Issues, on page 14
Shared Lines, on page 37
Turn On Do Not Disturb, on page 22
Sign-in to a WebEx Meeting
Your Phone