Ap 7161 Power Options Using Power Over Ethernet - Motorola AP 7161 Installation Manual

34

AP 7161 Power Options Using Power over Ethernet

Power over Ethernet (PoE) is the power source for an AP 7161 access point. For optimal performance, an AP 7161
can be powered by the following Motorola Solutions injectors and RFS controllers that support 802.AT PoE.
For installations requiring an outdoor PoE injector, the following Motorola Solutions options are recommended:
• AP-PSBIAS-7161-US
• AP-PSBIAS-7161-WW
The AP-PSBIAS-7161 is a 1-Port 802.3at PoE Gigabit Ethernet injector. The injector is IP66 rated for outdoor
deployments when used with the weatherproof kit supplied.
There are two power cord options for the AP-PSBIAS-7161 models. The AP-PSBIAS-7161-US comes equipped with
a cable with a standard three prong power plug. This plug can be removed by the installer if required when
connecting to an AC source. The AP-PSBIAS-7161-WW comes equipped with a cable with open leads. Mounting
kits are not supplied (see
numbers).
NOTE
If located within 100 meters of the controller and a PoE port is available, the AP 7161 access point can also be
connected directly to one of the following Motorola Solutions controllers:
• RFS4000
• RFS6000
• RFS7000
• NX9000
A standard CAT5E cable can be used to provide the connection to the AP 7161. The GE1/POE port on the AP 7161
is where the standard CAT5E cable will connect to the access point and use of the weatherproof RJ45 plug kit that
comes with the unit will maintain a weatherproof seal for outdoor installation at the ethernet port.
If a CAT5E cable is used to connect the access point to an RFS controller through a building egress, a suitable
lightning protection system should be considered. A professional installer should be consulted to identify an
appropriate system.
CAUTION
Outdoor PoE Hardware and Mounting Accessories on page 10
Product installation and mounting instructions are provided with the outdoor power
injector. Refer to the AP-PSBIAS-7161 Install Guide.
When using controllers, the total power limits for the AP 7161 must be considered.
The two radio configuration draws less power than a three radio configuration. If
sufficient power is not available, the AP 7161 software will disable the third radio
and throttle back performance on all radio and Ethernet interfaces.
AP 7161 Access Point Installation Guide
for mounting kit part