Safecard On Motherboard (Som) - Siemens Simatic box pc 627b Operating Instructions Manual

9.5

Safecard on Motherboard (SOM)

9.5
This application is used to monitor PC hardware (temperature, watchdog and fans) and to
display the current measured values. A GUI is used to configure the application and also to
activate the temperature monitoring watchdog function and fan monitoring function.
Your device is equipped with three temperature sensors, which are automatically detected
by the application.
Figure 9-1
(1)
(2)
(3)
The description of the driver and SOM program are available on the CD "Documentation and
Drivers" under Drivers & Updates\<device>\...
From the CD, run Install.bat and follow the instructions on your screen.
SIMATIC Box PC 627
Operating Instructions, Release 05/2006, A5E00362052-03
Safecard On Motherboard with three temperature sensors
Temperature range Here the current temperature and limit values are shown. You can
toggle the temperature display mode to indicate either the current
temperature, or the min./max. values measured since the start of the
application.
(1a)
(1b)
(1c)
Watchdog range Here, you can configure the watchdog function in your monitoring
application. You can specify the watchdog time, activate a PC reset
and activate / deactivate the watchdog.
Fan area You can read the current fan speed in this area.
(3a)
(3b)
9.5 Safecard on Motherboard (SOM)
Internal processor temperature
Device temperature beneath the power supply:
upper threshold can be set from 30°C to 80°C
Cooling air temperature surrounding the DVI connector:
- depending on device 3°C to 5°C higher than the ambient
temperature
- upper threshold can be set from 25°C to 55°C
Fan speed in the area close to the processor
Fan speed on the power supply
Functions
9-3