Making Cold Frothy Milk - Silvercrest SMA 500 A1 Operating Instructions Manual

7) Wait about 30 seconds. In this time the still liquid milk flows to the bottom.
8) Remove the lid
for example, a cappuccino.
Wait about 2 minutes before you heat up another portion of milk.

Making cold frothy milk

1) Fit the frothing whisk
the other whisk
2) Remove the carafe from the plinth
milk to at least the MIN mark inside. However, never fill it with milk beyond
the upper MAX marking (
When frothed, the volume of the milk increases significantly!
3) Place the carafe on the plinth
4) Put the lid on
5) Press the "Cold" button
The frothing whisk
6) The appliance switches itself off and the integrated control lamp goes out as
soon as the milk is frothed.
NOTE
► If you want to stop the preparation process before completion, press the
"Cold" button
preparation process will resume.
7) Wait about 30 seconds. During this time the still liquid milk flows to the
bottom.
8) Remove the lid
example, to make a cappuccino.
SMA 500 A1
and pour the milk froth into the desired container to make,
onto the drive shaft inside the carafe. You can clip
onto the whisk holder
and fill it with milk. Fill the carafe with
). Otherwise the appliance may overflow.
.
.
. The integrated control lamp lights up blue.
starts to turn, the milk is frothed.
. If you press the "Cold" button
and pour the milk froth into the desired container, for
.
again, the
GB
IE
9