P [Protect] - Panasonic Lumix DMC-FX38 Operating Instructions Manual

Advanced (Playback)
∫ To print the date
After setting the number of prints, set/cancel printing with the recording date by pressing
[DISPLAY].
•
When you go to a photo printing store for digital printing, be sure to order the printing of the
date additionally if required.
•
Depending on the photo printing store or the printer, the date may not be printed even if you set
to print the date. For further information, ask at your photo printing store or refer to the
operating instructions for the printer.
•
The date cannot be printed on pictures stamped with text.
Note
•
The number of prints can be set from 0 to 999.
•
With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
•
It may not be possible to use the DPOF print settings with other equipment. In this case, cancel
all the settings, and reset the settings.
•
If the file is not based on the DCF standard, the DPOF print setting cannot be set.
You can set protection for pictures you do not want to be deleted by mistake.
1
Select [PROTECT] on the [PLAYBACK] mode menu. (P18)
2
Press 3/4 to select [SINGLE] or [MULTI] and then
press [MENU/SET].
3
Select the picture, and then press
[MENU/SET].
When [MULTI] has been selected
•
Repeat these steps for each picture.
•
The settings are cancelled when [MENU/
SET] is pressed again.
4
Press [‚] to return to the menu screen.
•
Press [MENU/SET] to close the menu.
∫ Cancelling all the [PROTECT] settings
1
Select [CANCEL] on the screen shown in step
2 Press 3 to select [YES] and then press [MENU/SET].
3 Press [MENU/SET] to close the menu.
•
If you press [MENU/SET] while cancelling protection, the cancelling will stop halfway.
86
VQT1S07

P [PROTECT]

Press 2/1 to
select the picture.
[SINGLE]
Press 3/4/2/1
to select the
pictures.
2
and then press [MENU/SET].
[MULTI]