USE & OPERATION (CONTINUED)
CLEANING & DRAINING THE WATER TANK
Below are instructions on how to clean and maintain your air cooler. If the cooler will not be used for a
long period of time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the
separate Safety & Maintenance Guide.
Before cleaning the unit, switch the unit OFF and disconnect from the electrical socket.
Move the unit to a location where the water can be drained. Remove the cap from the Drain plug
located at the bottom of the unit. Allow the tank to empty.
Reﬁll the water tank with clean water, up to the maximum level and drain it completely.
Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive
elements or chemicals to clean this product.
When the product is not in use, store the unit in a dry place our of direct sunlight.
CLEANING THE CARBON DUST FILTER* AND HONEYCOMB COOLING MEDIA
The appliance is supplied with a Carbon Dust Filter* &
Honeycomb Cooling Media.
The Carbon Dust Filter* and Honeycomb Cooling Media are
located inside the Rear Grill. See Figure 1 for instructions on
how to remove them from the unit for cleaning and
Do not run the unit in COOL mode with stale water in the
tank. You must empty the water tank and reﬁll with fresh
water, especially if the tank has not been cleaned in a long
The cleaning frequency for the Honeycomb media depends
on local air and water conditions. In areas where the mineral
content of water is high, mineral deposits may build up on the
Honeycomb Cooling Media and restrict air ﬂow. Draining the
water tank and reﬁlling with fresh water at least once a week
will help reduce mineral deposits. If mineral deposits remain
on the Honeycomb Cooling Media, the media should be
removed and washed under fresh water. The media should
be cleaned every two months or sooner, depending on your
For best results allow the Honeycomb Cooling Media to dry
after each use by turning off the cool function 15 minutes
before turning the unit off.
Removing the Carbon Dust Filter*/ Honeycomb Cooling Media:
Remove all the screws from the Rear Grill.
Carefully push the left and right side of the rear grill and
pull out from the cooler.
Pull out the Carbon Dust Filter* and clean with water as
To release the Honeycomb Media pull out the Rear
Frame and slide the Honeycomb out of the frame.
Replace or clean media with water and a damp cloth as
WARNING: DO NOT operate the Air Cooler when the
Rear Grill or Rear Frame is removed from the Air Cooler,
or if there is a loose-ﬁtting Rear Grill or Rear Frame.
Doing so can cause serious injury or dangerous
*Applicable for models with Carbon Dust Filter only.