Configuration Of Communication Mode To Point-Of-Sale System; Configuration Of Serial Communication Mode; Configuration Of Ip Communication Mode - Ingenico FLEX IPP320 Installation Manual

• The terminal conducts a test of its IP connectivity and displays the result on

2. Configuration of communication mode to Point-of-sale System

o Configuration of serial communication mode
• On the idle screen, if «MENU» is not displayed above the F1 key, press the
• Press F1, the terminal displays (Main menu) screen.
•
• Using F2 or F3 to navigate, select (Term config) and press the green key.
• Select (POS comm) then press the green key.
• Select (Configuration) then press the green key.
• Select (RS232) then press the green key.
• Select required baud rate (9600 Bps recommended) then press the green key.
• The terminal displays (RS232 activated).
o Configuration of IP communication mode
• On the idle screen, if «MENU» is not displayed above the F1 key, press the
• Press F1, the terminal displays (Main menu) screen.
•
• Using F2 or F3 to navigate, select (Term config) and press the green key.
• Select (POS comm) then press the green key.
• Select (Configuration) then press the green key.
• Select (IP) then press the green key.
• The terminal displays (IP activated).
Next, the IP address of the Point-of-sale System from which transactions will be
sent must be registered on the FLEX terminal
FLEX iPP320 - Installation Guide_v1.50.docx
the screen (see Appendix C
yellow key followed by the "0" key to unlock the terminal menus.
Select (Configuration) then press the green key, the terminal displays
(Configuration) screen.
yellow key followed by the "0" key to unlock the terminal menus.
Select (Configuration) then press the green key, the terminal displays
(Configuration) screen.
for details).
21