Philips LBB 6186 Installation Instructions

DP 6000 DIGITAL PAGING SYSTEM
RECEIVER UHF
RECEIVER VHF
1. GENERAL INFORMATION
These installation instructions cover the following types of paging
receivers:
Colour
UHF 410 - 470 MHz
VHF 25 - 50 MHz
These high quality, lightweight Generation III paging receivers are
used in DP 6000 Digital Paging Systems.
The receivers are individually identified by the allocation of call
numbers, which are programmed into the receiver. Each receiver
will respond to calls made specifically to its own call number or to
group calls. A group call is a single call which can be received by
more than one receiver holder.
When placed in a storage rack and being called, the receiver returns
an absent signal to the DP 6000 system.
The versions of the receiver described in these installation
instructions are:
- the bleep only version producing a bleep and flash signal when it
is called.
- the display version producing both a bleep plus a flash signal and
digital information on the LCD.
Before using the receiver, it has to be programmed with the
necessary addresses and set to the system configuration.
The receiver can be programmed using the keyboard of the Control
Desk LBB 5800, Telephone Coupler LBB 5840/xx and the LBB 6000
Alpha-desk user editor (edit menu receives).
2. OPERATING CONTROLS AND DISPLAYS
2.1Operating Controls
2.1.1 ON/OFF/volume switch (fig.1B)
- position 0 = off
position I = on, with low bleep volume
position II = on, with high bleep volume
- When switching on, a single bleep is emitted and the personal
address is shown on the display (if present).
Philips
Communication &
Security Systems
Bleep only Display
Light Dark Light Dark
6080 6085 6081 6086
6180 6185 6181 6186
INSTALLATION
INSTRUCTIONS
LBB 6080/6081/6085/6086
LBB 6180/6181/6185/6186
A
Operating controls
- With rechargeable batteries installed, the receiver is always
"switched on" (low bleep volume when switch position is 0).
- When disposable batteries are installed, the info memory is
erased when the receiver is switched off.
2.1.2 RECALL button (fig.1A)
Note: applies to display version only.
- The RECALL button can be used to scroll from normal call
address to the two group addresses and to scroll the 5 info
messages.
2.2 External contacts
The three contacts (fig.1C) are for charging and absent indication
when the receiver has been placed in the storage rack.
Left - common
Middle - absent
Right - charging and code
(Refer to LBB 6150 Installation Instruction 76).
77
June 1992 Page 1 of 5
B
II
I
0
C